There are instructions for making a horse tire swing. This will require some artistic talent to draw a basic horse form and a certain strength to cut the deck. It will also require a strong ybico support to the weight of the child and swing. Thick branches are best. Here's how to make a horse tire swing. Items needed for a DIY horse tire swing: bias-ply tires (scrubbed and cleaned, clear-coated to prevent black comes out of clothing is optional) ybico Industrial scissors Bolts with nuts, washers, and cover caps (minimum 1 inch bolt length ) 2 eye bolts with nuts and washers for support and installation (minimum 1 inch) Keys (dimensioned ybico bolt head and nut) Drilling Tools (assistance holes) Poster board (greater than tire circumference) Pencil and chalk ropes, chains or cable (strong enough to keep the weight of the child and tires) Scissors Tape How to make a horse tire swing: Step # 1: Lay tires on the poster board. Use the pencil to draw a circle on the inside ybico and the outside circumference of the tire. Remove deck and draw horse pattern between the two lines (pattern should be in 5 sections: head, neck, body, legs and tail. No legs are pulled. The nose of the horse must meet the end of the tail). Locating the position of support holes will be (preferably where the neck meets the body and tail), and joining holes, wherein the sides of the tires will be bolted together (preferably 2 to the head, the neck 2, 2 or 3 of the body 2 of the blow, 2 to tail). Step # 2: Use scissors to cut out the pattern for DIY horse tire swing you make your own horse tire swing. Step # 3: Wrap the cut-out pattern around deck and tape in place. Use chalk to draw the outline of the pattern on the tires. Remove pattern when you make your own horse tire swing. Step # 4: Cut chalk outline horse using industrial scissors. Use cutting tool to make holes for studs and ends holes. Use industrial scissors to separate deck between the nose and tail of the horse pattern. Step # 5: Bolt together all parts of the horse tire swing with nuts and washers. Cover the ends of the bolts with caps. Attach eye bolts with nuts and washers (bolt end will be on the underside of the deck). Step # 6: Attach rope, chain, or cable eyebolts. Hang on mounting surface, holding two rope lengths separated to avoid entanglement with the child. This is a very important part of the instructions to make a horse tire swing. This is how to make your own horse tire swing. Check rope occasionally for wear. It is also very important for a DIY horse tire swing. This entry was posted in Uncategorized by guvde. Bookmark the permalink.
Proudly powered by WordPress | Wedding Blor Network
No comments:
Post a Comment